- AAAndrew A.Verified BuyerRated 4 out of 5 stars3 years agoSmall
Works Great.
Make sure you have a 5v power supply or Y power cables when using multiple on the same system.
- LSLarry s.Verified BuyerRated 1 out of 5 stars4 years agoPoor design
Power must be home run to panel, if you wire it incorrectly it will completely fry the board. This should be redesigned to only open/close contact wire to trip alarm and use remote power.
- JAJim A.Verified BuyerRated 5 out of 5 stars4 years agoReplaced defective part
The original part was broken. Konnected replaced the part, no questions asked and no charge. Very much pleased with their support. Thanks Andy,
- JAJim A.Verified BuyerRated 3 out of 5 stars5 years agoJust OK
Original detector had bad solder hour or I broke it trying to connect the slip on pin connectors. It seems very delicate. I re-soldered the pins to the board and checked it. It seems to be working but I donāt trust it. I tacked with TS and they said I was going to get a new board. It hasnāt shipped yet.
- MBMichael B.Verified BuyerRated 5 out of 5 stars5 years agoGreat Products
I've purchased many products from Konnected and am always pleased with both the quality of the products as well as support using them
Water Leak or Rain Sensor
$6.50
Skip to product information
Water Leak or Rain Sensor
$6.50
Detect water leaks or rain drops with this water droplet sensor. When a droplet of water falls on the flat sensor plate, the sensor will signal the controller.
Works with:
- Konnected Alarm Panel Add-on Board (1st or 2nd generation)
- Konnected Alarm Panel Pro
- Konnected DIY Prototyping kit
Specifications
Voltage: 3.3V - 5V DC
1 Digital output (wet/dry)
1 Analog outputĀ